Iphone locks after updating firmware canadian dating laws in ontario

Posted by / 03-Jun-2017 22:10

I press download, it first shows a box saying Downloading. I will pick up a new P4 tomorrow since I returned the one I had, and try again.

After going there, I press the red box saying there is a new firmware. Keep in mind I downloaded the firmware on the i Pad with nothing connected to it 3 - Once download was complete, I then connected the Ipad to the quad using the dongle adapter so you can link Quad Micro-USB i Pad-Lightning cable 4 - Once connection is complete, you can start the upgrade following button on the GO app screen Note: My RC was on but not connected during this process since the i Pad was directly connected to the Quad All went fine from there, took about 10 minutes to upgrade (an the annoying upgrading beeping soundtrack have been removed for this process) Thank you.

Please post your screen shots if you are experiencing trouble and I will assist you.

If you are updating through the app and are getting errors chances you updated the RC first and now the aircraft cannot update because you are getting an RC signal lost message.

SUCCESS in upgrading firmware in less than 10 minutes!!!

I am sorry many of you are experiencing update issues.

Other android users I know it's the same with them.

This is a saved piece of forum post text that I grabbed before I received my P4. (Note: I disconnected the micro USB cable from the P4 and plugged it back in.) 14. But it seems like DJI should do some needed improvements on their apps, since a lot of people seem to have the same problem. You may or may not then be told to reconnect the cable to the P4. I only have macs and i Pads, so I really hope I will get it to work. Disconnect full-size USB connector from the back of the RC leaving Apple Lightning cable attached to i Pad. Plug USB connector into DJI-provided adapter cable that has a female USB connector on one end and a micro-USB male connector at the other end of 4-inch cable. Plug micro-USB connector into micro-USB port next to micro SD slot on the side of the P4. (NOTE: The first two attempts, I turned the RC off and the firmware update failed to proceed.) So, now your i Pad or i Phone will be directly connected by USB cable to the P4 (the RC is now connected only wirelessly to the P4). If you are lucky like I was, the firmware update will start within 15 seconds of plugging micro USB cable into P4. P4 firmware update progress will be displayed as a percentage at bottom of DJI GO app screen. When firmware update completes, you will be instructed to disconnect the USB cable from the P4.On top of that, how do you have a relationship with Apple and can't even put out a product that is compatable with the latest OS.I'm not sure what to try next so if anyone has a suggestion, please post it.

iphone locks after updating firmware-32iphone locks after updating firmware-53iphone locks after updating firmware-89

It would just keep cycling and pausing but after 20 or 30 tries, it began to download.